SN74ALS575ADW

SN74ALS575ADW Overview

The package is in the form of 24-SOIC (0.295, 7.50mm Width). D flip flop is embedded in the Tube package. T flip flop is configured with an output of Tri-State, Non-Inverted. The trigger configured with it uses Positive Edge. Surface Mountmounts this electrical part. It operates with a supply voltage of 4.5V~5.5V. Temperature is set to 0°C~70°C TA. A flip flop of this type is classified as a D-Type. In terms of FPGAs, it belongs to the 74ALS series. In order for it to function properly, its output frequency should not exceed 30MHz. A total of 1elements are present in it. As a result, it consumes 17mA quiescent current. A total of 24 terminations have been made. The 74ALS575family includes it. An input voltage of 5Vpowers the D latch. This D flip flop belongs to the family of ALS. In this case, the electronic component is mounted in the way of Surface Mount. As you can see from the design, it has pins with 24. This device has the clock edge trigger type of Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. An electronic part designed with 8bits is used in this application. Despite its superior flexibility, it relies on 8 circuits to achieve it. There are 5V power supplies attached to it. There are 2 ports embedded in the flip flops. High efficiency requires the supply voltage to be maintained at 5V. The 24mA output current allows it to be designed with the greatest amount of flexibility. This input has 4lines.

SN74ALS575ADW Features

Tube package
74ALS series
24 pins
8 Bits
5V power supplies

SN74ALS575ADW Applications

There are a lot of Texas Instruments SN74ALS575ADW Flip Flops applications.

• Data transfer
• Divide a clock signal by 2 or 4
• Computing
• Balanced Propagation Delays
• Bus hold
• Modulo – n – counter
• Supports Live Insertion
• Computers
• Count Modes
• Frequency Dividers